Garmin 160C Fish Finder User Manual


  Open as PDF
of 34
 
Fishnder 160C Owner’s Manual
InstAllIng the fIshfInder 160c > trAnsducer InstAllAtIon
Mounting the Transducer on a Trolling Motor
To mount the transducer on a trolling motor:
1. Slide the large cable tie through the slot on the transducer
mount with the ridges of the band facing up until equal
lengthsextendonbothsidesofthemount.(NOTE: For cold
water, or heavy timber or debris areas, a metal 4-5" worm
gear clamp is recommended.)
2. Position the mount gasket on the curved top of the transducer
mount.
3. Place the transducer assembly against the motor body of the
trolling motor, with the front of the transducer pointed away
from the trolling motor propeller.
4. Wrap the two ends of the cable tie around the motor body.
Place the pointed end of the cable tie through the fastener
hole on the opposite end and pull it through until it is snug but
not tight. (The cable tie clicks when you pull it.)
5. Position the transducer so that it is parallel with the bottom
when in use, and make sure the gasket is aligned properly.
Pullthecabletieenduntiltight.Trimofftheexcess,if
necessary.Tightenthe10-32lockingnutuntilittouchesthe
mounting bracket and then tighten 1/4 turn more. (Do not
overtighten.)
6. Routethe30'(9m)transducercableusingthesuppliedcable
tiestosecurethecabletothemotorshaft.Youcanllthe
forward-facingportion(exceptthecabletiepocket)ofthe
transducer mount with sealant to avoid accumulating debris.
Cable tie
Mounting
gasket
 previous next