Filter
Top Products
8
9. RUDDERS
9.1 Identify the left and the right rudder
assemblies.
Red Dot = LEFT
Green Dot =RIGHT
9.2 Insert one nylon bearing into the bottom of
each hole in the rudder castings. (FIGURE 13)
9.3 Put one cotter pin on each rudder pin.
(FIGURE 13)
9.4 Set the casting on the gudgeons. (FIGURE
13)
9.5 Push the rudder pin UP through the lower
gudgeon and make sure to place a stainless
steel washer between the gudgeon and the
nylon bearing in the casting. (FIGURE 13)
9.6 Repeat step 4.5 for the upper gudgeon.
(FIGURE 13)
9.7 Secure the top of the rudder pin with a
second cotter pin. (FIGURE 13)
9.8 Repeat for the other rudder assembly.
10. TILLER CROSSBAR
10.1 Place the red dot end (left) of the tiller
crossbar on the red dot (left) rudder.
10.2 Insert the tiller crossbar onto the rudder
arm pin so that the crossbar sets on top of the
arm.
10.3 Capture the tiller arm to the tiller crossbar
with the keyhole retainer clip on the tiller arm.
(FIGURE 14)
10.4 Attach the tiller extension to the yoke of
the tiller crossbar by inserting the clevis pin
and retaining ring. (FIGURE 15)
FIGURE 13
FIGURE 14
FIGURE 15