Filter
Top Products
16. Shroud Extender Installation
16.1. The clevis pin holding the shroud to the
shroud adjuster must be removed and
replaced by the ball lock pin that is part of the
shroud extender wire assembly.
16.2. Using the clevis pin removed in #1
above, pin one end of the shroud extender
wire assembly to the shroud adjuster. For
single handed sailing the shroud tension
should be less than that for racing. This is to
reduce pressure on the quick release pin so
that it may be removed more easily to extend
the shroud.
16.3. Attach the other end of the shroud
extender wire assembly to the shroud per the
drawing. You may have to strip the wire
coating in order that the clamp will slide on the
shroud.
Note: The final tension of the shrouds and
shroud adjustment will vary according to
personal preference. Shroud tension must be
relieved to lower the mast.
17. FLOAT TOP/ LIFT ASSEMBLY
FIGURE 28
FIGURE 29
FIGURE 30
FIGURE 31
14
Slide float
shaft into
mast & rivet
in place.