Filter
Top Products
14.5 Attach the left shroud to the top hole of
the left shroud adjuster with a 1/4" x 1/2" clevis
pin and lock ring. Secure the base of the
shroud adjuster to the toggle with a clevis pin
and lock ring. Then secure the toggle to the
tang on the left hull using a clevis pin and lock
ring. (FIGURE 26)
*Note:
SEE UPRIGHT
INSTRUCTIONS
ON FOLLOWING
PAGE
14.6 Repeat step 10.9 for the right shroud and
shroud adjuster.
15. TRAPEZE WIRES
15.1 Untie and clear the trapeze wires.
15.2 Lead the trapeze shock cord through the
grommets on the outboard side of the
trampoline, then under the trampoline and
through the opposite grommets.
15.3 Arrange the trapeze wires so they lead
outside of the shrouds. Then tie the line to the
J & H handle with a bowline knot. After the line
is led through the thimble on the end of the
trapeze wire, attach the rope lock. Then tie the
end of the line to the shock cord with another
bowline knot. (FIGURE 27)
FIGURE 26
FIGURE 27
13