Filter
Top Products
SHEETING SYSTEM
Install as shown in Fig. 51. Tang fittings
are bolted with outboard rear cross bar
bolts. Hang Ratchet blocks on tangs. Hook
bungee towing tramp lacing. This holds
block upright. Tie sheet to Jenniker clew
and run around boat as shown in Fig 50.
Sheets run outboard of shrouds to inboard
of wing through ratchet block across tramp
and through opposite ratchet block. Run
sheet forward then in front of jib but behind
Jenniker system then tie to clew. Trapeze
wires must be run inboard of wing.
NOTES:
Jenniker should not be left furled and or
hoisted when not in use. The materials are
nylon and do not handle long term UV.
Jenniker is designed for down wind sailing.
You may broad reach with he Jenniker but
undu stress may be caused if attempting to
sail on a close reach or in higher winds.
FURLER AND BRIDLES
Install furler and bridles onto forward bow tangs. Wind the furler line into the drum.
Install using jib system as guide.
FURLER CLEAT
Install furler cleat onto Cat Cabin next to and left of existing jib furler cleat.
HALYARD BLOCK AND CLEAT
Install swivel block onto upper mast tang. Install halyard cleat into mast luff track using
screws and square nuts. Position in desired location (just above cooler).
JENNIKER HALYARD AND SWIVEL
Install swivel to head of Jenniker (plastic sleeve may need to be removed). Tie halyard
to "D" shackle and attach swivel. Run halyard up through halyard block and down mast
to cleat. Attach Jenniker tack to furler drum. Hoist Jenniker.
33. H21SC JENNAKER SYSTEM (option)
FIGURE 51
FIGURE 50
FIGURE 49
26