Filter
Top Products
4
3. LACING YOUR TRAMPOLINE
LINE STARTS AT GROMMET
IN TRAMP W/ A BOWLINE
KNOT.
3.1 Before lacing, slide the tramp into the tracks in both of the hulls. Be sure to slide back as
far aft as possible. Using soapy water helps with the installation of the tramp.
3.2 Place tramp lace bar in tramp as shown below. (FIGURE 4)
3.3 Follow the rear X-bar lacing diagram (Figure 5)
NOTE: Tighten tramp to individual preference. Do not use any tramp tightening device. This
may cause damage to the tramp.
INSERT ROD IN AFT LOOP OF THE TRAMP AS SHOWN
FIGURE 5
FIGURE 4