Filter
Top Products
38
37
A message will appear on the display periodically to remind you that you are using the Simulator.
Exit the Simulator by powering your 700 Series™ Fishing System off.
System Status
Use System Status to view system connections and to conduct a unit self-test.
The following screens are displayed in turn when you press the VIEW button when using System Status:
• Self Test
• Accessory Test
• GPS Diagnostic View.
Exit System Status by powering your Fishing System off.
Self Test
Self Test displays results from the internal diagnostic self
test, including unit serial number, Printed Circuit Board
(PCB) serial number, software revision, total hours of
operation and the input voltage.
Accessory Test
Accessory Test lists the accessories connected to the
system.
NOTE: The speed accessory will be detected only if the
paddlewheel has moved since your 700 Series™ Fishing
System was powered up.
System Status Accessory Test Screen
System Status Self Test Screen
GPS Diagnostic View
GPS Diagnostic View shows a sky chart and numerical data from the GPS receiver. The sky chart
shows the location of each visible GPS satellite with its satellite number and a signal strength bar.
A dark grey bar indicates that the satellite is being used to determine your current position. A light
gray bar indicates that the satellite is being monitored, but is not yet being used.
This view also reports the current position, local time and date, and other numeric
information. The current GPS Fix Type is reported as No Fix, 2D Fix, 3D Fix, or Enhanced. An
Enhanced fix has been augmented using information from WAAS, EGNOS, or MSAS. A 3D or
Enhanced Fix is required for navigation. HDOP (the Horizontal Dilution of Precision) is a GPS
system parameter which depends on the current satellite configuration. HDOP is used to
calculate the Estimated Position Error.
PC Connect (with PC Connect cable only)
Use PC Connect to update the software of the 700 Series™ Fishing System control head. This
feature requires the use of the PC Connect Cable. Complete instructions are included with the
PC Connect Cable accessory.
NOTE: The PC Connect Cable requires a separate purchase. For more information visit our website at
www.humminbird.com or contact our Customer Resource Center at 1-800-633-1468.
Exit PC Connect mode by powering the 700 Series™ Fishing System off.
GPS Diagnostic View
Satellite Being
Monitored
Satellite Being
Used
Current Latitude
and Longitude
Sky Chart
531427-1_C - 767_Man_Eng.qxd 10/25/2005 10:29 AM Page 46