Filter
Top Products
ICOM-manual
First steps
Power supply
The ICOM-200/201 uses a power supply with 8-12 VDC, 1A. Minus is placed
on the pin of the power supply connector. The current consumption is,
depending on the application, up to 400mA.
3
PC-Mode
After a reset or power-down the Tiny-Tiger
®
Economy inside the ICOM-241 is
testing if the PC mode pin is „low“. In this case, the ICOM switches to PC
mode/Debug mode. Is the pin „high“, the ICOM starts in run mode. The time
between power-on and first activity on the I/O pins is approx. 230 msec.
To set the ICOM-241 to PC mode, a reset or power-down is needed. Setting
the DIP switch to PC mode while in run mode is not sufficient.
Side view ICOM-241
3-2
Wilke Technology GmbH • 0241 / 918 900 • http://www.wilke.de/ • support@wilke.de