Filter
Top Products
56
8
SET MODE
Beep (band edge)
A beep sounds when an operating frequency enters
or exits an amateur band. This functions independent
of the confirmation beep setting (above).
The volume level can be set in level set mode. (p. 54)
Beep (confirmation)
A beep sounds each time a switch is pushed to con-
firm it. This function can be turned OFF for silent op-
eration.
The volume level can be set in level set mode. (p. 54)
■ Miscellaneous (others) set mode (continued)
ON OFF
Confirmation beep ON
(default)
Confirmation beep OFF
ON OFF
Band edge beep ON
(default)
Band edge beep OFF
Scan speed
The transceiver has 2 speeds for scanning, high and
low.
See p. 47 for scanning details.
HIGH LOW
High speed (default) Low speed
Scan resume
This item sets the scan resume function ON or OFF.
ON: scan resumes 10 sec. after stopping on a signal
(or 2 sec. after a signal disappears); OFF: scan does
not resume after stopping on a signal.
See p. 47 for scanning details.
ON OFF
Scan resume ON
(default)
Scan resume OFF
RF/SQL control
The [RF/SQL] control can be set as the RF/squelch
control (default), the RF gain control only (squelch is
fixed as open) or squelch control (RF gain is fixed at
maximum).
See p. 2 for details.
RF+SQL
RF
SQL
[RF/SQL] control as RF/squelch control
(default)
[RF/SQL] control as RF gain control
[RF/SQL] control as squelch control
Quick dualwatch
When this item is set to ON, pushing [DUALWATCH]
for 2 sec. sets the sub readout frequency to the main
readout frequency and activates dualwatch operation.
See p. 30 for details.
ON OFF
Quick dualwatch ON
(default)
Quick dualwatch OFF
Quick split
When this item is set to ON, pushing [SPLIT] for 2
sec. sets the sub readout frequency to the main read-
out frequency and activates split operation.
See p. 32 for details.
ON OFF
Quick split ON
(default)
Quick split OFF