Filter
Top Products
vi
CAUTIONS
ELECTROSTATIC DISCHARGE (ESD) AND ESD PROTECTION: ESD can
damage disk drives, add-in boards, and other components. This server can
withstand normal levels of environmental ESD while hot-swapping SCSI hard
disk drives. However, we recommend doing all procedures in this manual
only at an ESD-protected workstation. If one is not available, you can
provide some ESD protection by wearing an antistatic wrist strap attached to
chassis ground of the server—any unpainted metal surface—when handling
components.
HANDLING BOARDS AND MODULES: Boards and modules can be extremely
sensitive to ESD and always require careful handling. After removing a board
or module from its protective wrapper or from the server, place it
component-side up on a nonconductive, static-free surface. If you place the
baseboard on a conductive surface, the battery leads can short out. If they do,
this will result in a loss of CMOS data and will drain the battery. Do not slide
a board or module over any surface.
SERVER COOLING AND AIRFLOW: Operating the server with the covers
removed can damage the server components. For proper cooling and airflow,
always replace the covers before turning on the server.