Filter
Top Products
A. Specifications
Cables
Intel recommends the following cables for interfacing to the ZT 4807.
IDE
For proper operation, Intel recommends 80-conductor IDE cables for external IDE
connection. If the external IDE device is configured in a master/slave combination with an
on-board IDE device (CompactFlash or processor board mounted hard disk) a custom 80-
conductor IDE cable must be used. Industry standard 80-conductor IDE cables do not
connect PDIAG to the host connector. This causes BIOS drive detection and configuration
errors when a master/slave pair exists across the interface. An 80-conductor IDE cable for
use with the ZT 4807 is available as an accessory from Intel as part number ZT 90250.
Floppy/IDE Power
An IDE/floppy drive power cable (Intel part number A86460-001) is shipped with the
ZT 4807. This is a 20" Y cable with a 4-pin female D-shell power connector wired to a 4-pin
female mini-plug power connector and a second 4-pin female D-shell power connector. Use
this cable to connect from ZT 4807 output power connector
J9 to a floppy drive power input
connector and/or an IDE device power input connector.
PS/2 Keyboard/Mouse
Using the ZT 4807 Keyboard/Mouse connector (J15) for both PS/2 keyboard and PS/2
mouse connection requires use of a PC keyboard/mouse Y splitter cable, such as the IBM
ThinkPad Laptop Y Cable. This cable (P/N BC00210) may be obtained from Black Box
Corporation. Contact Black Box at (724) 746-5500, or visit their website at
http://www.blackbox.com. This cable can also be ordered as an accessory from Intel as
ZT 90249.
30