Filter
Top Products
38
Selecting the encryption key
1 Press the key programmed as Scrambler/ Encryption
Code (K2/K3/K5/K6/K7 models only) or press and hold the
key programmed as Scrambler/ Encryption for 1 second,
to enter Key Selection Mode.
2 Select the new Encryption key using the Side 2 and Side 3
keys or the <C and D> keys.
• There are 16 available Encryption keys (1 ~ 16).
• When a call is received, the transceiver will descramble the call
as long as the received code is in the encryption list.
3 Press the Side 1 key to set the new Encryption key.
Note: To return the transceiver to the default Encryption key
programmed, select “PRESET”. However, if you delete the
Encryption key (see below), it will not be recovered.
deleting the encryption key (k2/k3/k5/k6/k7 modelS only)
1 Press the key programmed as Key Delete to enter Key
Delete mode.
2 Select the current Encryption key using the Side 2 and
Side 3 keys or the <C and D> keys.
3 Press the B key to delete the Encryption key.
4 Press the Side 1 key to exit Key Delete mode.
Note: To delete all Encryption keys (when more than one key has
been set up), select “ALL”.
pASSword protection (k2/k3/k5/k6/k7 modelS only)
If the transceiver is password protected, entering an incorrect
password successively 15 times will automatically delete all the
Encryption keys.
• Turning the transceiver power OFF and the ON again will not reset
the number of attempts for entering an incorrect password.