Filter
Top Products
15
In-dash mounting template for X47EX, showing dimensions. NOTE: The
preceding figure is not printed to scale. A scaled template is available
for free download from our web site, www.lowrance.com.
For the X47
The X47 can be mounted in-dash using the removable scaled template
inside the back cover of this manual (page 43). The FM-6 mount kit
includes the necessary materials, but the instructions only appear here
in this manual.
Please read all the instructions before proceeding. NOTE: Recommended
tools for this job include: jig saw, drill, drill bit (for starting hole).
1. Select the desired mounting location. Make sure there is enough room
behind the dash to attach the unit's cable. The case is approximately
1-3/4" (45 mm) behind the mounting surface. You also need to allow an
additional 1" (25 mm) for the power/transducer cable and connector.
2. Cut or tear out the template in the back of this manual (page 43) and
tape it to the dash. Begin the cutout by drilling a starter hole near the
center of the template. Use a drill bit big enough for the jigsaw blade.
3. Slip your saw blade into the starter hole and then cut along the
outside line. Be careful when working around the corners, because
there is little room for error.
4. Remove the backing from one side of the double-sided mounting tape
contained in the mounting kit. Apply it to the outer ledge on the back
of your unit. Starting at the bottom center, work the tape around all
four sides of the unit. Cut off any excess tape when finished.
5. Attach the power/transducer cable to the back of the unit.
Millimeters
[Inches]
ALWAYS VERIFY DIMENSIONS
In-Dash
Template
R 7.9
[0.31]
Top
113.5
[4.46]
146.5
[5.76]