Filter
Top Products
16
6. Remove the backing from the exposed side of the tape. Carefully
place the unit into the dash cutout. Press down firmly around the
entire outer edge to make sure the unit is secured to the dash.
In-dash mounting template for X47. NOTE: This figure is not printed to
scale. See the back of this manual for a scaled template copy you can tear
out and use. Manual is available on our web site.
Bracket Installation
Mount the unit in any convenient location, provided there is clearance
when it’s tilted for the best viewing angle. You should also make sure
there is enough room behind the unit to attach the power/transducer
cable. (See the following drawings, which show the dimensions of a
gimbal-mounted X47EX sonar unit and an X47.)
Holes in the bracket’s base allow wood screw or through-bolt mounting.
You may need to place a piece of plywood on the back side of thin
panels to reinforce the panel and secure the mounting hardware.
Top
ALWAYS VERIFY DIMENSIONS.
Cut along this line