Filter
Top Products
8
with the alignment mark molded into the bracket. Place the ratchets
onto the transducer with the letter "A" aligned with the 12 o'clock
position on the transducer stem. These positions set the transducer's
coarse angle adjustment for a 14° transom. Most outboard and stern-
drive transoms have a 14° angle.
Insert and align ratchets.
Add ratchets to bracket and transducer.
2. Aligning the transducer on the transom.
A. One-piece bracket: Slide the transducer between the two
ratchets. Temporarily slide the bolt though the transducer assembly
and hold it against the transom. Looking at the transducer from the
side, check to see if it will adjust so that its face is parallel to the
ground. If it does, then the "A" position is correct for your hull.
If the transducer's face isn't parallel with the ground, remove the
transducer and ratchets from the bracket. Place the ratchets into the
Alignment letters
Alignment
positions
Transducer bracket
Transducer
Transducer
bracket
Ratchet
Ratchet
Transducer