Filter
Top Products
20
If that results in electrical interference, or if such a switch is not
available, we recommend connecting direct to the battery and in-
stalling an inline switch. This will let you shut off power to the
power cable when the unit is not in use. When you are not using
the unit, you should always shut off power to the power cable, es-
pecially when the power cable is disconnected from the unit.
Power and transducer connections for the X67C sonar
unit (direct battery connection shown).
If possible, keep the power cable away from other boat wiring, espe-
cially the engine's wires. This will provide the best isolation from elec-
trical noise. The power cable has two wires, red and black. Red is the
positive lead, black is negative or ground. Make sure to attach the in-
line fuse holder to the red lead as close to the power source as possible.
For example, if you have to extend the power cable to the battery or
power buss, attach one end of the fuse holder directly to the battery or
power buss. This will protect both the unit and the power cable in the
event of a short. It uses a 3-amp fuse.
CAUTION:
Do not use this product without a 3-amp fuse wired into the
power cable! Failure to use a 3-amp fuse will void your warranty.
NOTE:
For more corrosion protection in saltwater or high humidity envi-
ronments, apply a thin layer of electrical-grade grease to each end
of the fuse before installing it in the fuse holder.
This unit has reverse polarity protection. No damage will occur if the
power wires are reversed. However, the unit will not work until the
wires are attached correctly.
MOUNTING THE SONAR UNIT: In-Dash, Bracket or Portable
You can install the sonar unit on the top of a dash with the supplied
bracket. At the time of this printing, we do not produce an in-dash
mounting kit for the X67C. If you wish to check on the future availabil-
12 volt
battery
Black wire
Red wire with
3 amp fuse
To unit
Optional power off switch
for saltwater installations