Filter
Top Products
ENGLISH
35
5. Remove the lamp cover screw.
6. Remove the lamp cover in the direction of the arrow.
7. Open the cover sheet and remove the two screws
(slotted head screwdriver required) that lock down the
lamp unit. Do not remove any other screws.
8. Holding the handle and pull the lamp unit out toward your
side.
9. Install a new lamp unit in position securely.
10. Lock the lamp unit in place with the two screws removed
in step 7. Press on the handle until it folds over and close
the cover sheet.
11. Install the lamp cover back in its original position and
fasten with the fastening screw.
12. Plug in the video projector and turn on the power and
project the image.
• If the lamp is replaced before reaching its 2000 hours
lamp life, see “Reset Lamp Life” (
☞
P.30).
• If the lamp is replaced after reaching its 2000 hours
lamp life, see “Initialize the Lamp Life” (
☞
P.34).
(b)
(a)
Lamp cover
Cover sheet
Lamp unit