Filter
Top Products
ENGLISH
If the lens becomes dirty or smudged, clean it with a soft
dry cloth only. Use optical lens cleaners that are
approved for eyeglasses or cameras. Do not use a
dampen cloth, detergent solution, or thinner. It may
damage the lens and remain as stains.
When replacement parts are required, be sure to inform a
Marantz authorized service center. Use only replacement
parts specified by Marantz. Unauthorized substitutions
may result in fire, electric shock, or other hazards. And,
the warranty may not be guaranteed.
• Lamp Unit : LU-12VPS3
• Ceiling Mount kit : MOUNT 12
This kit is specially designed to mount the unit on ceiling.
• Extension Pole : EXT-81
This tool is to adjust height with the Ceiling Mount Kit
MOUNT 12.
CAUTION:
For ceiling installation, consult with the Marantz Authorized
dealer.
Optional Accessories
Replacement Parts
Cleaning the Lens
7. When the WARNING and STANDBY indicators go out,
color temperature adjustment is complete. Adjustment
takes about 4 to 5 minutes. When the color temperature
sensor is detached from the lens, the below message
appears on the screen.
8. Press the ENTER button to return to the menu and
disconnect the cable of the color temperature sensor
from the projector.
Note:
If color temperature adjustment is not correctly processed
or if adjustment processing is interrupted in course by
pressing the MENU button or for some other reason, the
below message appears on the screen.
Also, adjustment processing can be interrupted by pressing
the MENU button.
❖ Color Temperature Sensor Protection
If no operations are performed for approximately 10 minutes
from the moment color temperature adjustment processing
ends, power to the projector shuts OFF automatically in order
to protect the color temperature sensor. If power is shut OFF
to protect the color temperature sensor, do the following.
•
If the WARNING indicator does not light
When color temperature adjustment ends successfully
and the sensor protection feature trips, the projector goes
on standby. As usual, activate power by pressing either
the POWER ON button on the remote control or the
POWER button on the projector.
•
If the WARNING indicator lights
If color temperature adjustment does not end successfully
and the sensor protection feature trips, the projector's
WARNING and STANDBY indicators light simultaneously
to indicate the error mode. Unplug the power cable and
then plug it back in. Then, press either the POWER ON
button on the remote control or the POWER button on the
projector to reactivate power.
Press "Enter" to exit
Quit
Press "Enter" to exit
Complete
37