Filter
Top Products
PAGE 16 — MT-62HS — PARTS & OPERATION MANUAL — REV. #2 (12/15/03)
3. Move the
throttle lever
to the "IDLE" position (Figure 8).
Figure 9. Choke Lever (Closed)
Figure 8. Throttle Lever (Idle)
4. In cold weather, start the rammer with the
choke lever
in the
"Fully Closed" position (Figure 9). In warm weather or
when the engine is warm, the unit can be started with choke
halfway or completely open.
Figure 6. Fuel Shut-Off Valve (Open)
This section is intended to assist the
operator with the
initial start-up
of the
MT-62HS
rammer. It is extremely
important that this section be
read
carefully
before attempting to use the
rammer in the field.
DO NOT use your rammer until this section is thoroughly
understood.
CAUTION:
Failure to understand the
initial start-up
procedures
of the
MT-62HS
rammer could
result in severe damage to the rammer or
personal injury.
See Figure 1 (Page 13) for the location of any control referenced
in this manual.
Initial Start-up
The following steps outline the procedure for starting the engine:
1. Open the
fuel shut- off valve
by moving the
fuel cock
lever to the
open
position (Figure 6).
2. Turn the engine
ON/OFF
switch (Figure 7) to the
"ON"
position.
Figure 7. Engine ON/OFF Switch
MT-62HS — INITIAL START-UP