MT-62HS — PARTS & OPERATION MANUAL — REV. #2 (12/15/03) — PAGE 17
MT-62HS —INITIAL START-UP
8. If the engine does not start after repeated attempts,
check the spark plug for excess fuel. Clean and replace
the spark plug as needed.
9. If the carburetor is flooded or the crankcase is loaded with
excess fuel, open the drain plug as shown in (Figure 11) and
drain out excess fuel, then try and start engine.
5 Grip the recoil starter (Figure 10) handle and pull it until you
feel a slight resistance. Then pull sharply and quickly. Return
the recoil starter handle to the starter position before releas-
ing.
Figure 10. Recoil Starter
Figure 11. Fuel Drain Cock
6. If engine fails to start, move the choke lever (Figure 9) to the
half open position to avoid flooding.
7. Repeat steps 1 through 6.