Filter
Top Products
2 – QLA2340/2340L
Specifications
FC2354601-00 A 2-19
14. Create an alias entry for the new boot device (optional). For example:
ok nvalias fibredisk
/pci@1f,0/pci@1/QLGC,qla@4/sd@82,0
15. Set default boot device to be the new boot device (optional). For example:
ok setenv boot-disk fibredisk
2.5
Specifications
Tables 2-7 and 2-8 define the QLA2340/2340L specifications.
Table 2-7. QLA2340/2340L HBA Operating Environment
Environment Minimum Maximum
Operating temperature 0°C/32°F 55°C/131°F
Storage temperature -20 °C/-4 °F 70°C/158°F
Relative humidity (noncondensing) 10% 90%
Storage humidity (noncondensing) 5% 95%
Table 2-8. QLA2340/2340L HBA Specifications
Type Specification
Host bus Conforms to PCI Local Bus Specification, revision 2.2 and the PCI-X
Addendum, revision 1.0
PCI/PCI-X
signaling
environment
3.3 V and 5.0 V buses supported
PCI/PCI-X
transfer rate
132 MBps maximum burst rate for 32-bit PCI operation at 33 MHz
264 MBps maximum burst rate for 32-bit PCI/PCI-X operation at 66 MHz
264 MBps maximum burst rate for 64-bit PCI operation at 33 MHz
528 MBps maximum burst rate for 64-bit PCI/PCI-X operation at 66 MHz
1GBps maximum burst rate for 64-bit PCI-X operation at 133 MHz
Fibre
Channel
specifications
Bus type:Multimode fibre optic media
Bus transfer rate:200 MBps maximum at half-duplex
400 MBps maximum at full-duplex
Interface chip: ISP2312
CPU Single-chip design that includes a QLogic RISC processor, Fibre Channel
protocol manager, PCI/PCI-X DMA controller, and integrated
serializer/deserializer (SERDES) and electrical transceivers that can
auto-negotiate a data rate of 1 Gbps or 2 Gbps
RAM 256 KB of sync SRAM supporting parity protection
BIOS ROM 128 KB of flash ROM in two 64-KB, software selectable banks. The flash
is field programmable.