Q-Logic SANblade 2300 Marine RADAR User Manual


 
3 QLA2342/2342L
Fast!UTIL
3-8 FC2354601-00 A
Execution Throttle. This setting specifies the maximum number of
commands executing on any one port. When a ports execution throttle is
reached, no new commands are executed until the current command
finishes executing. The valid options for this setting are 1256. The default
is 16.
Fast Command Posting. This setting decreases command execution time
by minimizing the number of interrupts. The default is Disabled.
>4GByte Addressing. This option should be Enabled if the system has
more than 4 GB of memory available. The default is Disabled.
LUNs per Target. This setting specifies the number of LUNs per target.
Multiple LUN support is typically for RAID boxes that use LUNs to map drives.
The default is 8. If you do not need multiple LUN support, set the number of
LUNs to 0.
Enable LIP Reset. This setting determines the type of loop initialization
process (LIP) reset that is used when the operating system initiates a bus
reset routine. When this setting is Yes, the driver initiates a global LIP reset
to clear the target device reservations. When this setting is No, the driver
initiates a global LIP reset with full login. The default is No.
Enable LIP Full Login. This setting instructs the ISP chip to re-login to all
ports after any LIP. The default is Yes.
Enable Target Reset. This setting enables the drivers to issue a Target
Reset command to all devices on the loop when a SCSI Bus Reset command
is issued. The default is Yes.
Login Retry Count. This setting specifies the number of times the software
tries to log in to a device. The default is 8 retries.
Port Down Retry Count. This setting specifies the number of times the
software retries a command to a port returning port down status. The default
is 30 retries.
Drivers Load RISC Code. When this setting is Enabled, the
QLA2342/2342L HBA uses the RISC firmware that is embedded in the
software driver. When this setting is Disabled, the software driver loads the
RISC firmware that is stored in the QLA2342/2342L HBA BIOS. The default
is Enabled.
Disable Database Load Yes, No No
IOCB Allocation 1512 buffers 256 buffers
Extended Error Logging Enabled, Disabled Disabled
Table 3-2. Advanced Adapter Settings (Continued)
Setting Options Default