Filter
Top Products
3 – QLA2342/2342L
Fast!UTIL
FC2354601-00 A 3-11
■ Fibre Channel Confirm. This setting enables the host to send the FCP
confirmation frame when requested by the target. The default is Enabled.
This setting must be Enabled if the Fibre Channel Tape Support setting is
Enabled.
■ Command Reference Number. This setting is reserved. The default is
Disabled.
■ Read Transfer Ready. This setting is reserved. The default is Disabled.
■ Response Timer. This setting contains the value (in 100-microsecond
increments) used by a timer to limit the time waiting accumulating multiple
responses. For example, if this field is 8, the time limit is 800 microseconds.
The default is 0.
■ Interrupt Delay Timer. This setting contains the value (in 100-microsecond
increments) used by a timer to set the wait time between accessing (DMA)
a set of handles and generating an interrupt. The default is 0.
■ Data Rate. This setting determines the data rate. When this setting is 1, the
QLA2342/2342L HBA runs at 2 Gbps. When this setting is 2, Fast!UTIL
determines what rate your system can accommodate and sets the rate
accordingly. The default is 2.
3.3.3
Scan Fibre Channel Devices
This option scans the FC loop and lists all the connected devices by loop ID.
Information about each device is listed, for example, vendor name, product name,
and revision. This information is useful when configuring your QLA2342/2342L HBA
and attached devices.
3.3.4
Fibre Disk Utility
This option scans the FC loop and lists all the connected devices by loop ID. You
can select a hard disk and perform a low-level format or verify the hard disk.
CAUTION!
Performing a low-level format destroys all data on the hard disk.
3.3.5
Select Host Adapter
If you have multiple QLA2342/2342L HBAs in your system, use this setting to select
and then configure or view the settings of a specific QLA2342/2342L HBA.