Q-Logic SANblade 2300 Marine RADAR User Manual


 
FC2354601-00 A 8-1
Section 8
NetWare Driver Installation
(QL2300.HAM)
8.1
Introduction
This section provides instructions for installing the NetWare driver in an already
installed Novell NetWare 4.2, 5.x, or 6.x system.
NOTE: References to Novell NetWare 5.x and 6.x refer to versions that are
currently supported by Novell.
8.2
NetWare Driver Files and Parameters
The latest versions of the software drivers and documentation for NetWare 4.2, 5.x,
and 6.x are available on the QLogic Web site. Be sure to review the README.TXT
file for both new and changed information.
You can load the QL2300.HAM driver with optional switches to modify driver
functionality. The switches are described in table 8-1.
Table 8-1. QL2300.HAM Driver Parameters
Parameter Description
SLOT = n This switch specifies the PCI slot (slot n) in which the QLA23xx HBA
is installed. The driver must be loaded once for each QLA23xx HBA
in your system. For example:
LOAD QL2300.HAM SLOT=3
/LUNS This switch specifies that all logical unit number (LUN) devices are
scanned after the driver loads. Otherwise, NetWare only scans for
LUN 0 devices. This switch is required for multi-LUN storage
subsystems, for example, RAID subsystems. For example:
LOAD QL2300.HAM SLOT=3 /LUNS