Filter
Top Products
Installation
10
Fig. 2-7
Installing the
Sidelooker
Transducer
7. Move the bracket up or down so that the leading edge of the trans-
ducer has the clearance shown in Fig. 2-5.
8. Once the bracket is in the correct position, you can tighten the screws.
Mounting the Optional Sidelooker Transducer -
Transom-Mount Installation
1. The Sidelooker transducer allows the display unit to check the water
to either side of the boat. This is helpful when you are looking for fish
or structure near banks, or under docks or piers.
2. The M78930 Sidelooker transducer is attached to the same mounting
bracket used with the transom-mount transducer. See Fig. 2-7. Begin
by installing the transom-mount bracket as described earlier.
3. Remove the two screws and the bracket covering the paddle wheels.
4. Attach the Sidelooker transducer to the top of the transom mounting
bracket. Use the four panhead screws supplied. The fit should be
snug, but do not overtighten the screws.
5. Run the Sidelooker cable beside the depth cable for the transom-
mount transducer.