Filter
Top Products
27
Operating Instructions
Page Control
Pad
Up and down arrows –
(
<
and V)
During setup
– Use these controls to call up a choice or
move to the next line on a menu.
If the Zoom display is turned on
– If the manual zoom
feature is turned on, these will move the zoom display up
or down.
Left and right arrows –
(< and >)
During normal display
– Use these buttons to go to the next
display.
During setup
– Use these arrows to make a choice within a
line on the menu.
SETUP
To enter the Setup Menu –
Press
SETUP
at any time.
To go to the System Setup Menu –
Press this button
twice in all normal displays. If the sidelooker split screen
(Window Page options F, G, or H) is enabled, this button
must be pressed three times.
During setup
– Once you make a change, press
SETUP
to
save the change and go back to the normal display.
CLEAR
During normal display
–
When an alarm is triggered, use
CLEAR
to turn off the buzzer. (The alarm will continue to be
indicated on the display.)
During setup
–
Once you make a change, press
CLEAR
to
save the change and go back to the normal display.
When the unit is first turned on, it will present the normal FishFinder Page.
You can reach the Zoom, A-Scope and Bottom Lock Modes by pressing
buttons on the control panel. See Fig. 3-12.
ZOOM
The “Zoom” Mode shows a magnified view of a section of
the display area.
A-SCP
The “A-Scope” Mode shows a “real time” view of the area
directly under the transducer.