Filter
Top Products
GX1256S Page 15
4.7 OPTIONAL CMP25 RAM+ MIC INSTALLATION
1. Connect the RAM+ MIC Cable to the RAM MIC CONNECTOR on the
rear panel, then tighten the Cable Nut (See Figure 3).
2. Referring to Figure 3, make a 1.2” (30 mm) hole in the wall, then insert
the RAM+ MIC Cable into this hole. Connect the Gasket and Mount Base
to the RAM+ MIC Cable Connector using the Nut.
3. Drill the four Screw holes (approx. 2 mm) on the wall, then install the
Mounting Base to the wall using four screws.
4. Put the Rubber Cap on to the Nut. The installation is now completed.
Figure 3. RAM+ MIC Installation
Wall
Gasket
Cap
Nut
RAM MIC Cable