Filter
Top Products
GX1256SPage 28
6.18 TIME INDICATION
Press and hold the
[
16/9
]
and
[
H/L
(
POS
)]
keys while turn-
ing the transceiver on, the transceiver will display the TIME
on the upper side, if connected to a GPS receiver.
NOTE
The TIME OFFSET should be set to local time in the DSC/RADIO setup
mode when the radio is connected the GPS navigation receiver. To ad-
just TIME OFFSET to your local time, refer to section 7.6 TIME OFF-
SET.
6.19 RESETTING THE TRANSCEIVER’S MICROPROCESSOR
Resetting the microprocessor restores the initial, factory supplied conditions
in the transceiver. These are called the default conditions.
To reset the microprocessor, first turn the transceiver off. Then while press-
ing the
[
WX
]
and
[
SCAN
(
MEM
)]
keys, turn the transceiver on. The default
conditions are:
• No channels in SCAN memory.
• Channel 16 will be selected when the transceiver is turned on.
• WX channel 01 will be recalled when the
[
WX
]
key is pressed.
• Key beep will be on.
NOTE
Resetting the microprocessor will not erase DSC MMSI and Directory
information.