Filter
Top Products
HX600S Page 37
11. INSTALLATIONS OF OPTION
11.1 FVP-31 VOICE SCRAMBLER UNIT
1. Make sure that the transceiver is off.Remove the battery pack.
2. Locate the connector for the optional unit under the caution seal in the
battery compartment on the back of the transceiver; just peel off the cau-
tion seal.
3. Align the connector on the FVP-31 with the transceiver's connector and
gently press the unit into place.
4. Place the Sponge Sheet (supplied with the HX600S) on the FVP-31.
5. Affix the new caution seal (supplied with the FVP-31), and replace the
battery. Installation is now complete.
11.2 FBA-25A Alakline BATTERY Tray
FBA-25A is a battery case that holds six alkaline batteries and is used with
the HX600S transceiver.
1. Slide the batteries into the FBA-25A with the Negative [-] side of the batter-
ies touching the spring connections inside the FBA-25A.
2. Insert the FBA-25A into the battery compartment on the back of the trans-
ceiver, then close the Battery Pack Latch until it locks in place with a
“click.”
Note: The battery indicator on the transceiver is only applicable to the FNB-
V98LI rechargeable battery. Disregard this indication when using alkaline bat-
teries.
¯¯
¯¯
¯
¯¯
¯¯
¯
¯¯
¯¯
¯
Peel off the seal
Locate Connector
Sponge Sheet Affix the new Seal