Filter
Top Products
6017 Series Hot Oil Large Temperature Control Units Page 7
1 General Information
1-1 Introduction
Your Sterling/Sterlco 6017 Series hot oil temperature control unit
circulates thermal transfer-type oil through your process and to
precisely, automatically, and reliably maintain it at a temperature
you can select. The operating range of your temperature control
unit is from 100°F to 550°F (38°C to 288°C). The unit is best
suited for use with SterlTherm™ Heat Transfer Fluid. A
recommended list of commercially available heat transfer fluids
can be obtained through Sterling Customer Service.
Rapid recirculation of the fluid provides a close and uniform
temperature relationship between the TO PROCESS and FROM
PROCESS
lines. This does, of course, depend on the configuration
of your process, and any restrictions within the mold.
This recirculation, combined with the immersion heater and
optional cooling capability, gives fast and accurate response to
bring the fluid up to temperature, or to changes in the settings
when needed.
Performance is assured through matching the unique Sterlco
controllers to the Sterlco high temperature system. The two
systems are fully integrated to achieve accurate control.
1-2 Necessary Documents
The following documents are necessary for the safe installation,
operation, and maintenance of your Sterling/Sterlco 6017 Series
hot oil large temperature control unit. You can obtain additional
copies from Sterling, Inc. Make sure that appropriate personnel are
familiar with these documents:
; This manual.
; The electrical schematic and connection diagram in the control
enclosure.
; The manuals for accessories and options you’ve selected.
; The customer parts list in the control enclosure.