Filter
Top Products
2–4 445-0167-01-01
Using the S400 Remote Switch
The S400 Remote Switch performs the same function as the On/Standby
switch on the RS400.
Invert mode use
only
The S400 Remote Switch provides On/Standby control only when the
RS400 is operating in invert mode.
To use the S400 Remote Switch, the On/Standby switch on the RS400
must be turned to the On
() position. See “Operating in Invert Mode” on
page 2–5.
Purpose The S400 Remote Switch provides remote control of the RS400 from a
convenient location up to 25 feet (7.5 meters) away using the supplied
telephone cable.
Cable length You can use a longer cable up to a maximum recommended length of 50
feet (15 meters). Xantrex recommends using a high quality 4-wire
telephone cable wth 6-position, 4-contact connectors.
Important: When shore power is present, the S400 Remote Switch will
not change the operation of the inverter.
Figure 2-2
S400 Remote Switch
Inverter ON