Filter
Top Products
12
Audio interface manual
Fader section operation
Using the faders and status keys of the fader section, you can adjust the volume of
corresponding Cubase LE tracks, mute and solo them, and arm them for recording.
Operating the fader section
1
Assign the Cubase LE tracks
(channels) that you want to control
to the fader section.
About banks
After setting up control surface operation, the
main parameters of Cubase LE can be oper-
ated using the
fader and status keys.
A group of tracks operated by the faders
and status keys is called a “bank.” With the
, one bank of 8 adjacent tracks can be
controlled.
For example, if fader 1 is assigned to Cubase
LE track 1, tracks 1-8 can be controlled as
shown in the following diagram.
Status keys &
Faders
1 2 3 4 5 6 7 8
Track Tr1 Tr2 Tr3 Tr4 Tr5 Tr6 Tr7 Tr8
As the diagram shows, when tracks 1~8 are
selected, pressing
beneath once
switches the assignments as shown below.
Status keys &
Faders
1 2 3 4 5 6 7 8
Track Tr9 Tr10 Tr11 Tr12 Tr13 Tr14 Tr15 Tr16
Push beneath
The next lower bank of eight tracks (channels) is as-
signed to the fader section
Push beneath
The next higher bank of eight tracks (channels) is
assigned to the fader section
2
Use the faders to control the
volumes of the corresponding
tracks.
The faders control the volumes of their re-
spective tracks. Change the master volume
by moving the Master Fader.
3
To change the function of the
status keys for all the tracks,
press the soft key for the desired
function.
Use these keys to set the
functions of the status keys