Filter
Top Products
28
Audio interface manual
Effects in audio interface mode
The insert and send-return effects can both be used when the sampling frequency
is set to 44.1 kHz. Basic operation is the same but there are a few differences in the
menus.
NOTE
• Effects can only be used when the sampling rate
is 44.1 kHz. At all other times they are turned
OFF.
• Insert and send return effect settings are saved
when you end (EXIT) audio interface mode and
can be used again the next time.
Insert effect Send return effect
As in recording mode, you can select the insert
location and the insert effect algorithm, as
well as the effect patches to be applied to the
signal being recorded.
INSERT EFFECT menu options
Select the insert location
Insert on any INPUT 1–2.
(Reference: Operation Manual P45)
Apply the effect only to monitoring
The effect can be set to only be applied to the monitoring
signal and to not affect signals recorded in DAW software.
(Reference: Operation Manual P.89)
When used as an audio interface, the send
reverb can only be used for monitoring.
As in recorder mode, use the
SEND REVERB
EFFECT
menu to change the patch and use the
PAN/EQ
menu to set the
REV SEND
level that
adjusts the reverb depth.
Setting the reverb send level
REVERB SEND
Adjust the amount of reverb using the
REV
SEND
level of the
PAN/EQ
menu.
(Reference: Operation Manual P.44)
(Reference:
Audio interface manual – Mixer P.26
)