Filter
Top Products
19
Audio interface manual
NOTE
• If the Monitor button is on, the input signal
and the signal returning to the
via the
computer will both be output from the
at
the same time, creating a flanger-like sound.
To monitor accurately while adjusting the
recording level, turn the BALANCE knob to DIRECT.
• The meter above shows the signal level after it
has been processed internally by Cubase LE.
For this reason, a slight delay might occur from
the time a string is plucked until the level meter
moves. This is not a defect.
Adjust the recording level
9
While playing the instrument,
adjust the
input level and set
the Cubase LE recording level.
Check the recording level for Cubase LE by
viewing the level meter of the channel that
corresponds to the recording-enabled track. Set
it as high as possible without making the meter
peak.
When adjusting the level, do not move the Cubase
LE fader, but instead adjust the
gain.
Level Meter
10
11
After adjusting the recording level,
click the Monitor button so that it
becomes grey.
Monitor
button
This turns off display of the input level, and mutes
the signal from the computer to the
.
When the Monitor button is off, the signal just
before it is sent to the computer can be monitored
from the
PHONES and OUTPUT jacks.
Conrm that the Transport Panel is
displayed.
If the Transport Panel is not displayed, select
“Transport Panel” from the “Transport” menu.