A SERVICE OF

logo

Installing a drive in the auxiliary bay
You can install a digital audio tape (DAT) drive or an additional internal hard
disk in your server’s auxiliary bay (shown in the external view of the server in
the section “Your Server at a Glance” in Chapter 1).
Note: Your server may have come with a DAT drive already installed in the
auxiliary bay.
Follow these steps to install (or replace) a drive in your server’s auxiliary bay.
1 Open the server by following the instructions in the section “Opening the Server Safely”
earlier in this chapter.
Remember to wear a grounded wriststrap while installing an internal drive.
2 Touch the metal part of the power supply case inside the server to discharge
static electricity.
Always do this before you touch any parts or install components inside
the server.
Power supply
54 Chapter 3 / Expanding Your Server and Connecting Other Equipment