Integrated Cleaner Operation
A40-039 Rev 1 Page 19
• Place items in the baskets so that they do not trap air when immersed. Trapped air
will prevent the solution from contacting the soils. No cleaning will take place in the
areas not exposed to solution.
Figure 4-4 Trapped Air
• Do not overload baskets. Overloading will cause inconsistent cleaning.
• Use fixtures or racks to orient and separate parts and to prevent nesting. Nesting will
cause inconsistent cleaning and staining where the parts contact each other.
4.17.2 Suspending Parts
Suspend individual parts from wires so that they do not contact the tank walls or bottom.
Rods may be placed across the top of the tank to support the wires.
4.18 Cleaning the Parts
• Slowly lower the basket into the tank. Do not stir.
• Press the SELECT OPTION switch until the “SET SONICS min” LED is lighted.
• Press the ON/OFF switch to toggle the ultrasonics on. The Digital Number Display will count
down the time remaining. The ultrasonics will turn off when time has elapsed and the display
will show the set time.
• Slowly remove the basket from the tank. Allow the parts to drip into the tank.
• Rinse the parts with clean water and dry, if necessary.
4.19 Draining The Cleaner
Open the drain valve and allow the tank to drain.
Close the drain valve.
