Configuring IP Multicast 725
Multicast Static MRoute Summary
Use the Multicast Static Routes Summary
page to display static routes and their configurations.
To display the page, click IPv4 Multicast
→
Multicast
→
Static MRoute Summary in the tree view.
Figure 12-7. Multicast Static Routes Summary
The Multicast Static MRoute Summary page displays the following fields:
•
Source IP
— The IP Address that identifies the multicast packet source for this route.
•
Source Mask
— The subnet mask applied to the Source IP address.
•
RPF Address
— The IP address of the RPF neighbor.
•
Preference
— Enter the preference with which the static mroute to be considered against other
matching static mroute entry for a given source. The values should range from 1 to 255.
Displaying the Static Routes Summary Using CLI Commands
For information about the CLI command that performs this function, see the following chapter in the
CLI Reference Guide:
• Multicast Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 12-6. Multicast Static Route Configuration Commands
CLI Command Description
ip mroute Creates a static multicast route for a source range.
