768 Configuring IP Multicast
• PIM Global Configuration
•PIM Global Status
• PIM Interface Configuration
• Interface Summary
• Candidate RP Configuration
• Static RP Configuration
• SSM Range Configuration
• BSR Candidate Configuration
• BSR Candidate Summary
PIM Global Configuration
Use the PIM Global Configuration
page to configure the administrative status of PIM-DM or PIM-SM
on the switch.
To display the page, click IPv4 Multicast
→
PIM
→
Global Configuration or IPv6 Multicast
→
PIM
→
Global Configuration in the navigation tree.
Figure 12-33. PIM Global Configuration
The PIM Global Configuration page contains the following fields:
•
PIM Protocol
— Select PIM-DM or PIM-SM. Only one PIM protocol can be enabled on the switch at
a time. If you select PIM-SM, additional fields appear.
•
Admin Mode
— Select Enable or Disable from the drop-down menu to set the administrative status
of PIM on the system. The default is Disable.
•
Data Threshold Rate
— If PIM-SM is selected as the protocol, enter the minimum source data rate in
K bits/second above which the last-hop router switches to a source-specific shortest path tree. The
valid values are from 0 to 2000 K bits/sec. The default value is 0. This field is not available for PIM-
DM.
