xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
234
config cpu access_profile
• ethernet_type <hex 0x0-0xffff> − Specifies that the access profile will apply
only to packets with this hexadecimal 802.1Q Ethernet type value in the
packet header.
ip − Specifies that the Switch will look into the IP fields in each packet.
• vlan <vlan_name 32> − Specifies that the access profile will apply to only
this VLAN.
• source_ip <ipaddr> − Specifies that the access profile will apply to only
packets with this source IP address.
• destination_ip <ipaddr> − Specifies that the access profile will apply to
only packets with this destination IP address.
• dscp <value 0-63> − Specifies that the access profile will apply only to
packets that have this value in their Type-of-Service (DiffServ code point,
DSCP) field in their IP packet header
• icmp − Specifies that the Switch will examine the Internet Control
Message Protocol (ICMP) field within each packet.
• type <value 0-255> − Specifies that the access profile will apply to
this ICMP type value.
• code <value 0-255> − Specifies that the access profile will apply to
this ICMP code.
• igmp − Specifies that the Switch will examine the Internet Group
Management Protocol (IGMP) field within each packet.
• type <value 0-255> − Specifies that the access profile will apply to
packets that have this IGMP type value.
• tcp − Specifies that the Switch will examine the Transmission Control
Protocol (TCP) field within each packet.
• src_port <value 0-65535> − Specifies that the access profile will
apply only to packets that have this TCP source port in their TCP
header.
• dst_port <value 0-65535> − Specifies that the access profile will
apply only to packets that have this TCP destination port in their
TCP header.
• udp − Specifies that the Switch will examine the Transmission Control
Protocol (TCP) field within each packet.
• src_port <value 0-65535> − Specifies that the access profile will
apply only to packets that have this UDP source port in their
header.
• dst_port <value 0-65535> − Specifies that the access profile will
apply only to packets that have this UDP destination port in their
header.
• protocol_id <value 0-255> − Specifies that the Switch will examine the
protocol field in each packet and if this field contains the value entered
here, apply the following rules.
• user_define_mask <hex 0x0-0xffffffff> − Specifies that the rule applies to
the IP protocol ID and the mask options behind the IP header.
