xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
240
27
STACKING COMMANDS
The stacking configuration commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters)
in the following table.
Command Parameters
config box_priority current_box_id <value 1-12> priority <value 1-16>
config box_id current_box_id <value 1-12> new_box_id [AUTO | 1 | 2 | 3 | 4 | 5
| 6 | 7 | 8 | 9 | 10 | 11 | 12]
config box_type current_box_id <value 1-12> type [DGS-3324SR | DXS-3350SR |
DXS-3326GSR | BOX_NOTEXIST]
config all_boxes_id [static_mode | auto_mode]
show stack_information
Each command is listed, in detail, in the following sections.
config box_priority
Purpose Used to configure box priority, which determines which box
becomes master. Lower numbers have higher priority.
Syntax
config box_priority {current_box_id <value 1-12> priority
<value 1-16>}
Description This command configures box (switch) priority.
Parameters current_box_id <value 1-12> – Identifies the Switch being
configured. Range is 1-12.
priority <value 1-16> – Assigns a priority value to the box, with
lower numbers having higher priority. Range is 1-16.
Restrictions Only administrator-level users can issue this command.
Usage Example:
To configure box priority:
DGS-3324SRi:4#config box_priority current_box_id 1 priority 1
Command: config box_priority current_box_id 1 priority 1
Success.
DGS-3324SRi:4#
