Setup
Leica GS20 Field Guide-1.1.0en
80
9.8.4.1 Powering on the WoRCS
1. The Bluetooth Module is the only belt item with
configurable controls. By Default, Power should be set to
On, and Line should be set to Bluetooth.
2. Follow the procedure listed previously for charging the
batteries. Once the batteries are fully charged, you can
place them in any of the three bays of the battery insert
shown below. The battery insert is both hot swappable and
self-switching. The batteries will be drawn down from bay
one to bay three without interruption in power.
9.8.4.2 Checking the Bluetooth Link
If your Bluetooth link is successfully connected, the bluetooth
icon with a chain below and a status message “Bluetooth Link
Restored” will appear at the bottom of the screen. You can
now proceed to Checking the real-time Link; if not follow the
steps listed below:
1. Power on the GS20 and select 8
Setup, 2 Hardware
Management and the Bluetooth_Wireless Selection.
2. Expand the Wireless tree, expand the Bluetooth, and view
WoRCS.
3. If the GS20 has been linked to the WoRCS Bluetooth
Module, an address that corresponds to the address on
the top of the Bluetooth Module will appear. If the address
does not correspond, press menu and select clear.
4. If the address area displays zeros, you will need to
establish a connection.
5. Highlight the WoRCS branch and press enter; this will take
you to the Bluetooth Setup screen.
6. Press Inquire and wait until the Cancel button becomes
Inquire again.
7. You will see the Available Devices in the choice list. By
highlighting the available devices and pressing Enter, you
will see the entire list of available bluetooth devices in the
choice list. If multiple devices have been found, select the
device that matches your WoRCS bluetooth address,
displayed on the top of the bluetooth module.
