Setup
Leica GS20 Field Guide-1.1.0en
85
9.8.5.3 Checking the WoRCS Real-Time Link
Once the Bluetooth Link is established, you will need to make
sure that your real-time device is linked and active. If the
status message “Reference Data is Available” appears, setup
is complete, and there is no need to proceed any further.
Otherwise, follow the steps of the status check below.
9.8.5.4 WoRCS RTS
1. From the Main Menu select Status. Expand the Interfaces
branch and select Real-Time. If you have communication
with the RACAL module (RTS), you will see information
about the Station ID, frequency, signal strength etc.
)
The real-time screen does not refresh automatically; to
refresh the values, you will need to escape and re-
enter.
2. If the Station = -1, this means the Racal Unit does not have
a subscription. You will need to contact Racal-LandStar to
check the status of your subscription. To find the office
nearest you, go to www.landstar-dgps.com.
3. If the station id is present and all lights are on, on the
RACAL Module, escape to the Main Menu and select
8 Setup.
)
Verify the user-defined configuration named
“WRCSRTS” is selected; if WRCSRTS exists and is not
selected, highlight and press Enter, otherwise select
the default “RACAL”.
4. Press Enter again on the selected configuration to edit the
setup values.
5. Expand the Interfaces branch, highlight the Real-time
branch and press enter.
6. Make sure the Device is set to RTS, and the port is set to
WoRCS 1.
