A SERVICE OF

logo

Open as PDF
next previous
28
6.10 Bulk-12 and 14 Pressure Adjuster Assembly Kit
Part No. 986642
INSTALLATION INSTRUCTIONS:
1. Allow unit to cool down to a warm level.
2. Using a 1’’ size wrench (for 12 & 14# units) or a 1 1/4’’ size wrench (for 34# units), remove the
pressure adjuster from the bottom by turning in a counter clockwise direction.
3. Remove the assembly and place on the side.
4. Using a pick or small screwdriver, remove the items left inside.
5. Using the cleaning solution and cleaning pad, clean the area before replacing the unit and apply lubricant
supplied to the thread and o-ring seal area.
6. Taking the unit supplied, with spring and needle, re-install the assembly into the unit and tighten.
Needle, Pressure Adj.
O-Ring 2-010
O-Ring 2-018
Spring
Seal