30
6.12 Tank Heater Kit
Part No. 986643 for 115 VAC
Part No. 986644 for 230 VAC
INSTALLATION INSTRUCTIONS:
NOTE: DISCONNECT POWER FROM UNIT.
1. REMOVE 2 SCREWS FROM BOTTOM LIP OF PANEL AND TILT FORWARD.
2. DISCONNECT CONNECTORS AND GROUND WIRE AND SET ASIDE.
3. REMOVE FROM UNDER THE LIP OF THE FRAME, THE FOUR (4) SCREWS USED TO SECURE THE
ENCLOSURE TO THE FRAME.
4. LIFT THE ENCLOSURE FROM THE BASE UNIT, USING CAUTION NOT TO DAMAGE THE WIRING HARNESS.
5. FROM THE FRONT OF THE UNIT, CUT THE METAL TAPE ON THE SIDES OF THE TANK INSULATION IN
ORDER TO LIFT UP THE BOTTOM OF THE FRONT SECTION.
6. DISCONNECT THE HEATER WIRES (CUT WIRE TIES IF NECESSARY) AND PULL FREE FROM THE
INSULATION AND TAPE.
7. REMOVE THE HEATERS BY PULLING STRAIGHT OUT OF THE TANK.
8. INSTALL NEW HEATERS. RECONNECT AND DRESS THE WIRES ACCORDINGLY.
9. RETAPE THE INSULATION.
10. REPLACE THE COVER AND FRONT PANEL.
Tank Heater, 115 or 230VAC
Tank Front Ref.
