34
2.0 Functional Description
2.5 Microcomputer Interface
Bt8960
Single-Chip 2B1Q Transceiver
N8960DSB
2.5.4 Reset
The reset input (RST) is an active-low input that places the transceiver in an inac-
tive state by setting the mode bit (0) in the Global Modes and Status Register
[global_modes; 0x00]. An internal supply monitor circuit ensures that the trans-
ceiver will be in an inactive state upon initial application of power to the chip.
2.5.5 Registers
The Bt8960 has many directly addressable registers. These registers include con-
trol and monitoring functions. Write operations to undefined registers will have
unpredictable effects. Read operations from undefined registers will have unde-
fined results.
2.5.6 Timers
Eight timers are integrated into the Bt8960 to control the various on-chip meters
and to aid the microcomputer in stepping through the events of the startup
sequence.
The structure of each timer includes down counter, zero detect logic, and con-
trol circuitry, which determines when the counter is reloaded or decremented.
For each of the eight timers, there is a 2-byte timer interval register that deter-
mines the value from which the timer decrements. There are three 8-bit registers:
the Timer Restart Register [timer_restart; 0x0C], the Timer Enable Register
[timer_enable; 0x0D], and the Timer Continuous Mode Register
[timer_continuous; 0x0E]. These registers control the operation of the timers.
Each bit of the 8-bit registers corresponds to a timer. Each logic-high bit in
timer_restart acts as an event that causes the corresponding timer to reload. Each
logic-high bit in timer_enable acts to enable the corresponding timer. Each
logic-high bit in timer_continuous acts to reload the counter after timing out.
Each counter is loaded with the value in its interval register. The counter dec-
rements until it reaches zero. Upon reaching zero, an interrupt is generated if
enabled by the Interrupt Mask Low Register [mask_low_reg, mask_high_reg;
0x02, 0x03]. The interrupt is edge-triggered so that only one interrupt will be
caused by a single time out.
