Filter
Top Products
10 78-8130-6741-6 Rev G
Step 11. The prompt line will display: Download Completed Successfully, when
finished. The marker types legally allowed in the country selected in Step 6
above will be activated at this time.
Step 12. Multiple units may be configured at this point by simply connecting the next
locator, powering it on, and clicking Download.
Step 13. Click Exit when all locators have been updated.
C. Enabling/Disabling Marker Types
Menu [6] + >>More [SK:4] + Setup [SK:6] + >>More [SK:6d] + Marker Type [SK:6f]
Note: U-Model Locators will default with all marker types enabled (✓)
Step 1. Press the up/down arrows [SK] to highlight
a utility to enable or disable.
Step 2. Press Enabl/Disabl [SK].
− Only the markers that are enabled (✓)
will be available in the locate mode.
Step 3. Press Locate/OK [5] to save settings or Exit
[SK] to cancel.
D. Single Marker Locate
Step 1. Press Locate/OK [5]
Step 2. Press Marker [SK]
Step 3. Press Markr 1 [SK Toggle] to select
desired utility.
Step 4. Markr 2 should be OFF.
Note: Only the marker types enabled in the setup
menu will be shown. (See 4.C. Enabling/Disabling
Marker types). When scanning for markers, the
Gain Level [12] should be set high.
− When a marker is detected, adjust the
Gain [4] down until the bar graph opens.
− The bar graph will close, the audio will
be steady, and the Signal Strength [10]
will be maximum when the locator
detects a marker of the specified utility
and has pinpointed its location..