Filter
Top Products
12 78-8130-6741-6 Rev G
Step 3. To save the depth reading, press Mem
Select [SK].
− Five depth readings can be saved with
the time, date, and its identification
number.
− Save [SK] will place each entry in
sequential order in memory (M1 - M5)
until five readings have been stored.
The unit will overwrite saved entries
in excess of five, beginning with M1.
Step 4. Optional: Press Clear All [SK] to delete all stored depth information.
Step 5. Press Mem Select [SK] to select a specific memory location to store the depth
readings. When the preferred location appears on the screen, press Save [SK].
The display and memory location will populate with the current information.
Step 6. Each memory location can be reviewed by pressing Mem Select [SK].
Step 7. Press Locate/OK [5] to return to Marker Locate Mode.
G. Passive Electronic Marker (Non-iD) Depth
Step 1. Lower the tip of the locator to the ground over the targeted marker.
Step 2. Press Depth [SK].
− The locator will examine the targeted marker.
− The display will instruct the operator to raise the unit 6 inches (15.2 cm)
from the ground.
Note: This 6-inch (15.2 cm) rise must be exact for the depth reading to be accurate.
A suggestion is to utilize a 15.2 cm (6 inch) piece of plastic pipe or wood as a spacer
between the ground and the tip of the receiver for this precise measurement.
Step 3. Raise the unit 6 inches (15.2 cm). Press
Depth [SK] key again. The estimated depth
of the marker from ground level will be
displayed.
− Five depth readings can be saved with
the time and date.
Step 4. To access the memory locations, press Mem
Select [SK].
− Save [SK] will place each entry in
sequential order in memory (M1–M5)
until five readings have been stored.
The unit will overwrite saved entries in
excess of five, beginning with M1.