Filter
Top Products
ASUS A7V133 User’s Manual80
4. BIOS SETUP
4. BIOS SETUP
Boot Menu
Other Boot Device Select [INT18 Device (Network)]
Configuration options: [Disabled] [SCSI/Onboard ATA Boot Device] [INT18
Device (Network)] [LANDesk (R) Service Agent]
Plug & Play O/S [No]
This field allows you to use a Plug-and-Play (PnP) operating system to con-
figure the PCI bus slots instead of using the BIOS. When [Yes] is selected,
interrupts may be reassigned by the OS. When a non-PnP OS is installed or
you want to prevent reassigning of interrupt settings, select the default set-
ting of [No]. Configuration options: [No] [Yes]
Reset Configuration Data [No]
The Extended System Configuration Data (ESCD) contain information about
non-PnP devices. It can also hold the complete record of how the system
was configured the last time it was booted. Select [Yes] only if you want to
clear these data during the Power-On Self Test (POST). Configuration op-
tions: [No] [Yes]
Boot Virus Detection [Enabled]
This field allows you to set boot virus detection, ensuring a virus-free boot
sector. The system halts and displays a warning message when it detects a
virus. If this occurs, you can either allow the operation to continue or use a
virus-free bootable floppy disk to restart and investigate your system. Con-
figuration options: [Disabled] [Enabled]
Quick Power On Self Test [Enabled]
This field speeds up the Power-On-Self Test (POST) routine by skipping
retesting a second, third, and fourth time. Configuration options: [Disabled]
[Enabled]
Boot Floppy Seek [Disabled]
When enabled, the BIOS will seek the floppy disk drive to determine whether
the drive has 40 or 80 tracks. Configuration options: [Disabled] [Enabled]
SCSI/ATA100 Boot Sequence [ATA100/SCSI]
Configuration options: [ATA100/SCSI] [SCSI/ATA100]
Load Onboard ATA Bios [Auto]
Configuration options: [Auto] [Disabled]
Primary VGA Bios [PCI Card]
Configuration options: [PCI Card] [AGP Card]