Filter
Top Products
5. Advanced operation
Factory calibration – Color space:
When ITU 709 is selected, the White Color point and the RGB color primaries are ad-
justed according to the target HDTV / sRGB color space defined in the ITU-709 recom-
mendation. RGB primary calibration is performed within the physical limitation of the
LCD panel used.
Only in case the User preset has been selected it is possible to get access to the color
regulation commands described hereafter.
To select a color temperature preset
1. Bring up the OSD main menu.
2. Navigate to the Picture menu.
3. Enter the Color Temperature submenu.
4. Select one of the available color temperature presets and confirm.
Note: If you selected the User color temperature preset, a new menu will be displayed allowing you to
manually adjust the gain and offset of red, green and blue.
5.1.6 Gamma
About gamma presets
The available gamma presets for your display are:
• CRT (Gamma 2.2)
• Native (no correction curve is applied)
• DICOM (grayscale levels are following closely the DICOM curve)
Factory calibration – Grayscale tracking:
When Gamma is set to “CRT” or Color Temperature preset is set to “ITU 709” mode, a
Grayscale Color Tracking is implemented according to the factory calibration on differ-
ent gray level.
To select a gamma preset
1. Bring up the OSD main menu.
2. Navigate to the Picture menu.
3. Enter the Gamma submenu.
4. Select one of the available gamma presets and confirm.
5.1.7 Sharpness
To adjust the sharpness level
1. Bring up the OSD main menu.
2. Navigate to the Picture menu.
3. Enter the Sharpness submenu.
The command bar Sharpness is highlighted.
4. Set the sharpness level as desired and confirm.
(451920610993)K5903021 MDSC-2226 01/03/2013
35