Filter
Top Products
6. Important information
• The equipment must be earthed by a minimum 18 AWG, maximum 6 foot (1,8m) long wire connected
to the ground connection at the rear.
• The compliance of this monitor with Medical Safety and EMC requirements has been evaluated using
the external (optional) Skynet medical power supply model BAR-A159. If a different power supply will
be used, further investigation for Safety and EMC requirements, have to be performed at system level.
Power cords:
• Utilize a UL-listed detachable power cord, 3-wire, type SJ or equivalent, 18 AWG min., rated 300 V
min., provided with a hospital-grade type plug 5-15P configuration for 120V application, or 6-15P for
240V application.
• Do not overload wall outlets and extension cords as this may result in fire or electric shock.
• Mains lead protection (U.S.: Power cord): Power cords should be routed so that they are not likely to
be walked upon or pinched by items placed upon or against them, paying particular attention to cords
at plugs and receptacles.
Connections
Any external connection with other peripherals must follow the requirements of clause 16 of IEC60601-1
3rd ed. or Table BBB.201 of IEC 60601-1-1 for the medical electrical systems.
Water and moisture
The equipment is IP21 compliant (IPx5 front side only).
The power supply is not a pproved for IP21. The power supply must be mounted in a flat
position for best resistance to fluids.
Ventilation
• Do not cover or block the ventilation openings in equipment.
• Heed the necessary free space around t he equipment to allow enough air flow for cooling of the equip-
ment.
Installation
• Place the equipment on a flat, solid and stable surface that can support the weight of at least 3 e quip-
ments. If you use an unstable cart or stand, the equipment may fall, causing serious injury to a child
or adult, and serious damage to the equipment.
• Do not allow to climb or rest on the equipment.
• When adjusting the angle of the equipment, move it slowly so as to prevent the equipment from moving
or slipping off from its stand or arm.
• When the equipment is attached to an arm, do not use the equipment as a handle or grip in order to
move the equipment. Please refer to the instruction manual
of the arm for instructions on how to move
the arm with the equipment.
• Provide full attention to safety during installation, periodic maintenance and examination of this equip-
ment.
•Sufficient expertise is required for installing this equipment, especially to determine the strength of the
wall for withstanding the display’s weight. Be sure to entrust the attachment of this equipment to the
wall to licensed contractors of Barco and pay adequate attention to safety during the installation and
usage.
• Barco is not liable for any damage or injury caused by mishandling or improper installation.
General w arnings
• All devices and complete setup must be tested and validated before taking into operation.
• The installer needs to foresee a backup system in case the video falls away.
50
(451920610993)K5903021 MDSC-2226 01/03/2013